Pull on Instructions

Step 1

Undo the velcro tabs and pull the inner strap through the eyelet as far as possible to achieve the largest possible entry space for your foot.

Step 2

Pull the support over the foot and the closure as high as possible.

Step 3

Make sure the sole is pulled towards the heel, with the seam on top centered on the instep.

Step 4

The mini-piston should be positioned above the outer ankle bone (malleoli).

Step 5

Hold the position in place and pull the inner strap forward through the eyelet.

Step 6

Thread the inner strap through the opening in the outer strap. At the same time, keep the mini-piston position fixed.

Step 7

Correct pre-tension of the system is essential for proper function. To ensure correct pre-tension of the system (1) Pull the lateral velcro closure until the (2) Mini-piston is extended 3 millimeters from its original state.

Step 8

Tighten the strap and close the interior and exterior velcro fasteners. During this step, the lower leg should be tilted slightly forward.

Step 9

Correct the pre-tension of the closure after the first movements of the ankle in different directions. If you wear the brace for a longer period of time, check the pre-tension again and correct the pre-tension if necessary.